Some `deno_std` tests were failing to print output that was resolved
after the last test finished. In addition, output printed before tests
began would sometimes appear above the "running X tests ..." line, and
sometimes below it depending on timing.
We now guarantee that all output is flushed before and after tests run,
making the output consistent.
Pre-test and post-test output are captured in `------ pre-test output
------` and `------ post-test output ------` blocks to differentiate
them from the regular output blocks.
Here's an example of a test (that is much noisier than normal, but an
example of what the output will look like):
```
Check ./load_unload.ts
------- pre-test output -------
load
----- output end -----
running 1 test from ./load_unload.ts
test ...
------- output -------
test
----- output end -----
test ... ok ([WILDCARD])
------- post-test output -------
unload
----- output end -----
```
If we strip out unprintable chars, we don't see the full filename being
requested by permission prompts. Instead, we highlight and escape them
to make them visible.
This changes the lockfile to not store JSR specifiers in the "remote"
section. Instead a single JSR integrity is stored per package in the
lockfile, which is a hash of the version's `x.x.x_meta.json` file, which
contains hashes for every file in the package. The hashes in this file
are then compared against when loading.
Additionally, when using `{ "vendor": true }` in a deno.json, the files
can be modified without causing lockfile errors—the checksum is only
checked when copying into the vendor folder and not afterwards
(eventually we should add this behaviour for non-jsr specifiers as
well). As part of this change, the `vendor` folder creation is not
always automatic in the LSP and running an explicit cache command is
necessary. The code required to track checksums in the LSP would have
been too complex for this PR, so that all goes through deno_graph now.
The vendoring is still automatic when running from the CLI.
This looks like a massive PR, but it's only a move from cli/tests ->
tests, and updates of relative paths for files.
This is the first step towards aggregate all of the integration test
files under tests/, which will lead to a set of integration tests that
can run without the CLI binary being built.
While we could leave these tests under `cli`, it would require us to
keep a more complex directory structure for the various test runners. In
addition, we have a lot of complexity to ignore various test files in
the `cli` project itself (cargo publish exclusion rules, autotests =
false, etc).
And finally, the `tests/` folder will eventually house the `test_ffi`,
`test_napi` and other testing code, reducing the size of the root repo
directory.
For easier review, the extremely large and noisy "move" is in the first
commit (with no changes -- just a move), while the remainder of the
changes to actual files is in the second commit.
2024-02-10 20:22:13 +00:00
Renamed from cli/tests/integration/run_tests.rs (Browse further)
